[. . . ] Installing the Suction Cup Mount Finding Places and Routing to Them 1. Highlight an option that will help you find your destination, such as Auto Fuel, Food & Drink, or Lodging. [. . . ] Keep this guide in a handy place for future reference. QuestTM 2 Quick Reference Guide Turning the Quest On Press and hold the Power key on the front of the unit to turn it on. Select a suitable location for installing the unit that allows routing of the power cord and does not interfere with vehicle operation. Select a location where the Quest's flip-up antenna has an unobstructed view of the sky. For optimal use, position the antenna parallel to the surface of the road. Release tab Suction cup Vehicle Installation 1. Align the ball on the end of the suction mount with the socket (hole) on the back of the cradle. Angle the Quest forward and fit the bottom of the Quest into the cradle. To ensure a tight grip, clean and dry your windshield before you mount the suction cup. Plug the power cable into an available receptacle. To install the vehicle suction cup mount: To find a place and route to it: To stop or resume the current route: To add via points (extra stops) during a route: To find an address and route to it: Cradle Lever Suction cup tab NOTICE TO STATE OF CALIFORNIA DRIVERS: California Vehicle Code Section 26708 (a) (1) provides that drivers in California should not use suction mounts on their windshield or side or rear windows. For available accessories, refer to the Garmin Web site at www. garmin. com. Also, refer to the Owner's Manual for instructions on using the included mounting disk with the suction cup mount. January 2006 Printed in Taiwan Adding Detours and Planning Routes 1. From the Detour Distance page, highlight the distance for which you would like to alter your route, and press OK. Your original route is recalculated to avoid the upcoming section of road. Select one of the three options, and then select your starting location. Your Quest calculates the route. Setting Your Home Location and Resetting Trip Info 1. Highlight one of the options: Use Current Location, Use Find Menu, or Use Map, and then press OK. [. . . ] The data is reset. To reset the trip data or the maximum speed: Press and hold FIND to navigate to your Home location. Press IN and Power if your Quest freezes (stops responding to button presses). To adjust the backlight: Trip Information Page To adjust the external speaker volume: 1. [. . . ]